How Painters Tape Can Save You $1000′s
Many Years ago I had the opportunity to refit a 50′ yacht – complete from front to back (or properly stated bow to stern). However, before this project started, the owner was fixated on using painters masking tape and laying out every detail for the boat – not once, not twice, but several times in some cases, and not all in the same day… this went on for several days. We even used cardboard to mock up cabinets and equipment!
Even though I was being paid well to go along with this process and redo layouts more times than I care to remember, I could only think of one thing – man this guy is anal – how many times can you do this! Move this line 1/2″ that way, no, lets do that again and make it 3/4″. Let me say, in that week I had thought of dropping the job many times each day – all I could think of was “How anal will this guy be once I start the actual work?”
Standard Wall Framing for Drywall
In a typical home standard wall heights are 96 3/4″ to 97″ depending on the moisture content of the framing material. In most construction wall framing you will have a single base plate and double top plate with 92 1/4″ pre-cut studs. As with all things in construction, there is a very good reason for these dimensions and the resulting total wall height. If you are using 1/2″ drywall you will have 1/2″ on the ceiling and 2 – 48″ wide horizontal sheets on the wall for a total of 96 1/2″. This leaves 1/4″ t0 1/2″ of space below the drywall board at the floor.
This spacing is critical and must be allowed for. On average, walls shrink in height about 1/4″ and if you do not allow for this space and fit your drywall boards tight from ceiling to floor, the pressure on the horizontal joint will likely cause unsightly problems, possibly causing plaster to crack, tape to separate and bulging, or all three problems. When properly installed, with the top board tight to the ceiling and the lower board tight to upper board the two sheets can move down with the wall framing as it shrinks – this will ensure the drywall joints remain free from pressure as the wall shrinks preventing any bulges and related problems at the joints.
See the image below for details on this required spacing:
MDF vs Real Wood Moulding?
About 90% of new homes today use MDF mouldings. Is this a good choice? Should you use MDF mouldings in your home? This depends on several factors including budget and finishes. I’ll go over each type of moulding below and point out the pros and cons on each type.



